Water pressure and hot water in Sandwich.

Low water pressure

Low pressure can come from several places: a partially closed valve somewhere in the system, scale build-up in older pipework (more common in the harder-water villages), a failing pressure-reducing valve, or simply a system that was never balanced correctly. We check the straightforward causes first, since replacing pipework is a last resort, not a first guess.

Airlocks

An airlock (water flows from one tap but not another, or a tap splutters and stops) is usually a trapped pocket of air in the pipework rather than a supply problem. Often clearable on site by running taps in the right sequence or bleeding the affected point; a recurring airlock in the same spot can point to a pipe run that needs a proper look.

Immersion heaters and cylinders

Immersion heater not heating, tripping the electrics, or heating water that stays lukewarm: we can diagnose and replace the immersion element and thermostat, which is standard electrical-plumbing crossover work. Hot water cylinder issues (not holding temperature, leaking, or an ageing cylinder near end of life) we assess and advise honestly on repair versus replacement.

Boiler-side faults

Being Gas Safe registered means we do not have to guess whether a fault is water-side or boiler-side before diagnosing it, or hand you off to someone else halfway through. See our boiler and gas safety page for the full scope of what that covers.